Replacing Mow-Ball Or Line Plates; Mow-Ball Disassembly; Mow-Ball Assembly - Generac GC2200T Manual Del Propietário

Maintenance and Troubleshooting

Replacing Mow-Ball or Line Plates

Mow-Ball Disassembly

1. See Figure 4-1. Align the hole in the anti wrap can-
ister (A) with the hole in the internal housing.
Figure 4-1. Quick Lock Head Disassembly
2. Insert a Phillips-head screwdriver (B) through the
hole in the anti wrap canister and into the hole in
the internal housing.
3. Rotate Mow-Ball assembly (C) until the screw
driver slides into a hole in the shaft.
4. Looking down at the top of the frame, turn the
Mow-Ball clockwise until it unscrews completely
from the bearing housing.
NOTE: If the Mow-Ball continues to turn, but does not
come off, verify the screwdriver is locked into the shaft.
NOTE: If the Mow-Ball will not turn by hand, loosen the
bolt in the bottom of the Mow-Ball with a 9/16" socket.
5. Slide the line plates off the shaft.

Mow-Ball Assembly

WARNING
Personal injury. Verify all tools have been removed
from unit after service. Failure to do so could result
in personal injury or equipment damage
NOTE: Improper installation can damage trimmer bear-
ings.
1. See Figure 4-2. Place spacer (A) and anti wrap
canister (B) onto the shaft. The anti wrap canister
lip must be facing up as shown.
2. Slide line plates (C) onto the shaft with the follow-
ing requirements:
Line plates must be facing top up as shown in 
•
Figure 4-2.
• The flat at the center of each line plate (D) must
align with the flat on the shaft.
16
B
A
C
010607
.
(000491)
• The tabs on the underside of the line plates must
fully engage with tab holes (E) on the topside of the
line plates.
3. Place the head of Mow-Ball bolt (G) so it is sitting
in the hex cavity at the bottom of the Mow-Ball (F).
4. Looking down at the top of the frame, hold the bolt
head in place with your finger and turn the Mow-
Ball counterclockwise to start the bolt into the shaft.
5. Tighten the assembly securely by turning the Mow-
Ball counterclockwise when looking down on the
top of the frame.
6. Verify there are no gaps between the components
A
B
D
E
F
G
Figure 4-2. Cord Head Assembly.
Owner's Manual for Trimmer/Mower™
C
010608