LG WM4500HA Serie El Manual Del Propietario página 31

Ocultar thumbs Ver también para WM4500HA Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE
• If the water level and temperature are safe, the
door lock LED turns off and the door unlocks
once the wash movement has stopped.
• If the water level is too high, the door will not
unlock, and this function cannot be used.
• If the temperature in the drum is higher than
113 °F (45 °C), a short warning chime sounds and
this function is not allowed for safety.
• This function is disabled during the Tub Clean
cycle.
• To preserve wash performance, wash time may
be extended depending on when garments are
added to a cycle.
• Be careful when opening the door as wet
laundry may drip or fall out.
Cold Wash
Press the Cold Wash button to save energy by
using cooler water. It will increase the wash and
rinse times to maintain wash performance.
• Wash time will increase up to several minutes
with this option.
• For best wash results, only wash small loads (less
than 8 lb) with this option.
ezDispense
Use the Detergent Level and Softener Level
buttons to set up and control the ezDispense
function.
• Use the manufacturer's recommendations on
the detergent or fabric softener package when
setting the ezDispense amounts for a standard
8-12 lb (4-6 kg) load.
• The default settings are configured to dispense
1.5 oz (45 ml) of detergent and 1 oz (30 ml) of
softener for 8-12 lb (4 - 6 kg) of normally soiled
laundry.
• The default amounts can be increased or
decreased in 0.1 oz (3 ml) increments, within a
range of 0.3 oz (9 ml) to 6.0 oz (180 ml). The
amount dispensed may vary slightly depending
on the model.
Changing Default Dispense Amounts
1
Press the Power button to turn on the
washer.
2
Press and hold the Detergent Level or
Softener Level button for 3 seconds.
3
Turn the knob to increase or decrease the
amount of detergent or fabric softener. The
amount (in fluid ounces) is shown in the
display.
4
Press and hold the Detergent Level or
Softener Level button for 3 seconds to save
the changes.
Changing Dispense Amounts for a
Single Load
1
Press the Power button to turn on the
washer.
2
Turn the knob to select the desired cycle.
3
Press the Detergent Level or Softener Level
button to increase or decrease the dispensed
amount from the set defaults.
Buttons Indicator
4
Press the Start/Pause button to start the
cycle.
NOTE
• Most cycles will automatically use the default
amounts you have set, indicated by the Normal
LED light on the Detergent Level and Softener
Level buttons.
OPERATION
31
Dispensed Amount
More
Normal
Less
Off

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Wm4500hbaWm4500h-a serieWm1455ha serieWm1455hwa.abwepusWm4000ha serieWm4000hba ... Mostrar todo

Tabla de contenido