Cadet The Com-Pak Max CM162 Guia Del Propietario página 3

How do I configure my wattage?
STEP 1 Multi-Watt Element Wiring Configuration:
The multi-watt heaters listed below are factory set for the highest possible wattage. If you would like to keep the wattage
at the highest setting, proceed to Step 2. If you would like to reduce your heater's wattage from the factory setting, refer
to the table below that corresponds to your heater model. Once you are finished, proceed to Step 2.
FOR MODELS CM162 & CM162T
FOR MODELS CM202 & CM202T
FOR MODELS CM208 & CM208T
Installation Instructions
Part Two
1600 watt
configuration shown above
DO NOT DISCONNECT THE YELLOW CONNECTOR FROM TERMINAL "A"
2000 watt
configuration shown above
DO NOT DISCONNECT THE YELLOW
CONNECTOR FROM TERMINAL "D"
2000 watt
configuration shown above
DO NOT DISCONNECT THE YELLOW
CONNECTOR FROM TERMINAL "D"
WARNING
Turn the electrical
power off at the
electrical panel
board (circuit
breaker or fuse
box) and lock or
tag the panel board
door to prevent
someone from
turning on power
while you are
working on the
heater. Failure
to do so could
result in serious
electrical shock,
burns, or possible
death.
WARNING
Risk of Electrical
Shock. Connect
grounding lead to
grounding wire
provided. Keep all
foreign objects out
of heater.
WARNING
Risk of Fire.
Heater must be
kept clear of all
obstructions: a
minimum of 3' in
front; 6" on both
sides and above.
Heaters must be
kept clean of lint,
dirt and debris.
3