Reese Towpower MULTI-FIT Instrucciones De Instalación página 5

VEHICLE FRAME
EXISTING HOLES
HOLE 1
SIDE PLATE ASSEMBLY
CENTER SECTION
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly; tighten all fasteners to proper specifications (page 1)
97-04 FORD F-150 PICKUP (OLD BODY STYLE)
1. Lower spare tire.
2. Place 1/2" x 2 1/4" bolts and 1/4" bolt plate in rear most hole in frame. Both sides.
3. Aligning hole 1 in bracket with the rear most hole in frame. Raise hitch side bracket, 3/8" bolt plate, 1/2"
conical washer, and 1/2" nut into position, both sides. loosely install nut.
4. Install the 1/2" x 2 1/4" carriage bolt and 1/4" bolt plate though hole in frame that aligns with hole 5 in hitch
side bracket. Install 3/8" bolt plate, 1/2" conical washer and 1/2" nut, both sides, loosely install nut.
5. Install the M12 x 45mm hex bolt and 1/4" bolt plate though hole in frame that aligns with hole 4 in hitch side
bracket. Install 1/2" conical washer and m12 nut, both sides, finger tight.
6. Install center section as pre-assembled on front page with (4) 3/8" x 1 ¼" bolts and washer nuts, both sides.
Align center section of hitch with center of vehicle. Finger tighten fasteners.
7. Tighten hitch side bracket to frame. Tighten side plate assembly to side bracket. Tighten side bracket
assembly to center section.
8. Raise spare tire back into place.
1/2" X 2 1/4" CARRIAGE BOLT
M12 X 45MM BOLT
1/4" X 1" X 1 1/2"
BOLT PLATE
3/8" x 1-1/4" x 2 1/2"
BOLT PLATE
1/2" CONICAL WASHER
1/2" x 2 1/4" HEX BOLT
1/2" NUT
3/8" WASHER NUTS
3/8" x 1-1/4" x 2 1/2"
BOLT PLATE
1/2" CONICAL WASHER
1/2" NUT
INSTALLATION C
TOOLS REQUIRED
1/4" x 1-1/2" x 3"
BOLT PLATE
9/16", 3/4" SOCKET
18MM SOCKET
TORQUE WRENCH
SAFETY GLASSES
3/8" x 1 1/4 bolt
HITCH SIDE BRACKET
HOLE 5
HOLE 4
3/8" x 1-1/4" x 2 1/2"
BOLT PLATE
1/2" CONICAL WASHER
1/2" NUT
1/2" CONICAL WASHER
M12 NUT