1�0 Introduction; 1�1 Foreword; 1�2 Warnings - Dantherm HPP-i 8 Manual Del Propietario/Instalación

OWNER/INSTALLATION MANUAL
1�0 INTRODUCTION
1�1 FOREWORD
Thank you for choosing this product, which is designed
for quiet and energy efficient operation. It is the ideal
way to heat your pool in an environmentally friendly
way.
This guide provides information needed to install and
operate the product effectively. Please ensure you
read this manual and use the correct installation and
operating procedures.
This manual is intended for installers and users�
Read the entire manual before using the heat
pump� Awareness of the correct operating
procedure for the machine and any safety devices
is important, to avoid damage or injury�
The appliance can be used by children aged from 8
years and above and persons with reduced, physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without
supervision.
1�2 WARNINGS
Important safety information is contained in this manual
and marked on the heat pump.
Please read and follow all safety advice�
The refrigerant used in this heat pump is R32�
This refrigerant is environmentally friendly, but
safety instructions must be strictly adhered to�
4
The WARNING sign denotes a hazard� It calls
attention to a procedure or practice, which if not
adhered to could result in injury� Warning signs
and procedures must be complied with�
If a refrigerant leak is suspected stop using the
heat pump and contact the service department�
info@dantherm�com
Take the following precautions in order to avoid
any danger:
REFRIGERANT SAFETY:
This heat pump contains R32 refrigerant� Work
on the refrigeration system, repair and disposal
must be carried out by appropriately qualified and
registered engineers�
Repair, service and disposal must be carried out in the
EU by F-Gas registered engineers.
Completely de-gas the refrigerant before any brazing
is performed. Brazing can only be carried out by
technicians trained to EU 517/2014.
Risk assessments must be carried out before
maintenance or repairs are started.
Appropriate safety measures and risk assessments
must be taken before work commences.
Do not attempt to work on the equipment by
yourself�
Consult the qualified engineer undertaking the work to
establish all requirements before work commences.
1007332 ISSUE 5