Dantherm HPP-i 8 Manual Del Propietario/Instalación página 6

OWNER/INSTALLATION MANUAL
Installation must be carried out by competent people,
in accordance with this manual.
INSTALLATION:
Read the instructions before installation, use and
maintenance.
If R32 gas leaks during the installation process, stop the
installation immediately and call the service centre.
If a repair is required, please contact the nearest after-
sales service centre.
To avoid over heating or over cooling of pool water
check and set the temperature on the control panel.
The heating performance can be improved by
insulating the flow and return pipework.
It is recommended that a cover is used on the
swimming pool to reduce heat losses.
AIRFLOW:
The heat pump must have access to adequate airflow.
See section 3.1.
Do not place obstructions that will block air flow near
the inlet or outlet.
ELECTRICAL SAFETY:
Mains power isolator should be out of reach of children.
After a power cut, when the power supply is restored,
the heat pump may start up without warning.
Electric storms can damage electronic equipment.
Ideally the heat pump should be switched off at the
mains.
6
HEAT PUMP MALFUNCTION:
WARNING: Isolate heat pump electrically and wait
3 minutes before removing panels or entering heat
pump.
Refer to the user check list in section 5.2 and the error
codes listed in section 5.3 before initiating a service call.
Do not attempt to interfere with any internal control
settings as these have been factory calibrated and
sealed.
Any sign of abnormal operation such as water dripping
should be reported immediately to the installer. If
in doubt or if advice is required contact the Service
department.
MAINTENANCE:
Isolate the power supply of the heat pump and wait 3
minutes before cleaning examination or repair.
Please clean this machine with household detergents
or clean water. NEVER use petroleum spirit, thinners or
any similar fuel.
Check bolts, cables and connections regularly.
DISPOSAL:
Repair, service and disposal of redundant heat pumps
must be completed by authorised technicians. It is
illegal to allow refrigerant gases to escape to air.
Do not attempt to work on the equipment by yourself.
Improper operation may cause danger.
1007332 ISSUE 5