LUCCI Air NORDIC Manual De Instrucciones página 9

Nordic Installation Instructions
Remote Control Buttons
A - FAN SPEED CONTROL BUTTON:
There are 6 available speeds. "I" button is for the lowest speed, and "VI" button
is for the fastest speed.
NOTE: when you turn on the fan for the first time or switch the main power to the
controller, you need to start the fan on high "VI" speed first and then choose a
lower speed. 5-10 seconds is required to allow the DC fan to respond to the
remote for each speed or fan direction selection.
B - FAN OFF BUTTON:
Press the button to turn the fan off.
C - REVERSE FUNCTION BUTTON:
Press the button to activate the reverse running function. The fan must be
operating to activate the reverse function.
D - LIGHT CONTROL BUTTON:
Press the button to turn the light ON/OFF.
THE RECEIVER PROVIDES THE FOLLOWING LEVEL OF PROTECTION:

Lock position: the receiver has a built in safety feature to protect against obstruction during operation.
The motor will be locked from operation and will disconnect from power after 30 seconds of interruption.
Please remove obstacles before re-starting. To reset, simply turn off the power supply to the fan motor
and re-start.

Over 80W protection: when the receiver detects power consumption which is greater than 80W, the
receiver power will be stopped and operation will immediately discontinue. Turn the receiver power on
after 5 seconds to restart the fan.
REPAIRING THE FAN RECEIVER & REMOTE PAIRING
Should the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired. Below are the operating symptoms and method to repair the pairing of the DC
ceiling fan remote and receiver.
Issues:

Loss of control - Fan is only running at high speed after installation

Loss of control - No reverse function after installation

Loss of control - Remote cannot communicate with fan
Solution:
A. Switch OFF the main power to the ceiling fan for 30 seconds.
B. Press and hold the "
to the receiver of the ceiling fan.
C. Turn ON and change the speed of the ceiling fan via the transmitter to check the operation and successful
pairing.
8 | P a g e
" button on remote for 3－5 seconds within 60 seconds of switching the power ON
Fig. 15
WA-3B-LK