Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Nordic Installation Instructions
INSTALLING THE CANOPY (Fig. 9)
1.
Tuck all the connections neatly into the ceiling outlet box.
2.
Loosen the 2 screws from the bottom of the mounting bracket.
3.
Slide the canopy up to the mounting bracket and place the canopy keyholes over the screws on the
mounting bracket. Turn the canopy until it locks in place at the narrow section of the key holes and secure
it by tightening the 2 set screws. Avoid damaging the electrical wiring prepared previously.
BLADE INSTALLATION (Fig.10)
1.
Loosen the 3 blade holders from the motor.
2.
Secure the blade to the blade holder by tightening the 2 blade screws with washers provided. Fig.10
3.
Repeat to install the remaining blades to the blade holders.
4.
Install the blade assemblies to the motor by tightening the 2 motor screws. Fig.11
5.
Finally, install the bottom cover to the lamp bracket by rotating it clock wise. Fig. 12
5 | P a g e
FINISHING THE INSTALLATION
Fig. 9
Fig. 11
Fig. 10
Fig. 12
WA-3B-LK
Publicidad
Tabla de contenido
