Important Safety Instructions; Injury To Persons; Important Safety Information - Campbell Hausfeld FP260000 Instrucciones De Operación

Operating Instructions and Parts Manual

Important Safety Instructions

InStrUctIOnS PertaInInG tO a
rISK OF FIre, electrIc ShOcK, Or

InJUry tO PerSOnS

This manual contains safety, operational
and maintenance information. Contact
your Campbell Hausfeld representative
if you have any questions.
calIFOrnIa PrOPOSItIOn 65
This product or
its power cord may
contain chemicals known to the State
of California to cause cancer and birth
defects or other reproductive harm.
Wash hands after handling.
You can create dust when
you cut, sand, drill or grind
materials such as wood,
paint, metal, concrete, cement, or other
masonry. This dust often contains
chemicals known to cause cancer, birth
defects, or other reproductive harm.
Wear protective gear.
General
Since the air compressor and other
components used (filters, lubricators,
hoses, etc.), make up a high pressure
pumping system, the following safety
precautions must be observed at all
times:
1. Read all manuals included
with this product
carefully. Be thoroughly
familiar with the controls
and the proper use of the
equipment.
2. Follow all local electrical and
safety codes as well as in the US,
National Electrical Codes (NEC) and
Occupational Safety and Health Act
(OSHA).
3. Only persons well acquainted with
these rules of safe operation should
be allowed to use the compressor.
4. Keep visitors away and NEVER allow
children in the work area.
5. Wear safety glasses and
use hearing protection
when operating the pump
or unit.
6. Do not stand on or use the pump or
unit as a handhold.
www.chpower.com
7. Before each use, inspect compressed
air system and electrical components
for signs of damage, deterioration,
weakness or leakage. Repair or
replace defective items before using.
8. Check all fasteners at frequent
intervals for proper tightness.
equipment and controls can
cause electrical arcs that
will ignite a flammable gas
or vapor. Never operate or repair in or
near a flammable gas or vapor. Never
store flammable liquids or gases in the
vicinity of the compressor.
Compressor parts may be hot
even if the unit is stopped.
9. Keep fingers away from a running
compressor; fast moving and hot
parts will cause injury and/or burns.
10. If the equipment should start
to abnormally vibrate, STOP
the engine/motor and check
immediately for the cause. Vibration
is generally a warning of trouble.
11. To reduce fire hazard, keep engine/
motor exterior free of oil, solvent, or
excessive grease.
with a setting no higher than 150 psi
MUST be installed in the tank for this
MANUAL
compressor. The ASME safety valve
must have sufficient flow and pressure
ratings to protect the pressurized
components from bursting.
for maximum operating pressure.
Do not operate with pressure switch
or pilot valves set higher than the
maximum operating pressure.
12. Never attempt to adjust ASME safety
valve. Keep safety valve free from
paint and other accumulations.
safety valve. Keep safety valve free
from paint and other accumulations.
to repair or modify a tank!
Welding, drilling or any other
modification will weaken the
tank resulting in damage from rupture
or explosion. Always replace worn or
damaged tanks.
13. Tanks rust from moisture build-up,
14. Fast moving air will stir up dust
Motors,
electrical
15. Indoor use only.
16. To reduce the risk of electrical shock,
SPrayInG PrecaUtIOnS
flammable materials in
vicinity of open flame or near
ignition sources including the
compressor unit.
17. Do not smoke when spraying paint,
18. Use a face mask /
An ASME code
19. Do not direct paint or other sprayed
safety relief valve
20. When spraying or cleaning with
See compressor
specification decal
hOSe PrecaUtIOnS
21. Inspect hose before use.
working pressure marked
Never remove or
on hose.
attempt to adjust
Never
hose.
attempt
22. Do not wrap hose around body.
chemicals.
2
FP260000
Drain liquid from
tank daily.
which weakens the tank. Make
sure to drain tank daily and inspect
periodically for unsafe conditions
such as rust formation and corrosion.
and debris which may be harmful.
Release air slowly when draining
moisture or depressurizing the
compressor system.
do not expose to rain. Store indoors.
Do not
spray
insecticides, or other flammable
substances.
respirator when spraying
and spray in a well
ventilated area to prevent
health and fire hazards.
material at the compressor. Locate
compressor as far away from
the spraying area as possible to
minimize overspray accumulation on
the compressor.
solvents or toxic chemicals, follow
the instructions provided by the
chemical manufacturer.
Do not
exceed
Do not twist, bend
knot, or abrade
Keep away from
hot surfaces and
Save theSe InStrUctIOnS
DO nOt DIScarD