Tripp-Lite SNMPWEBCARD Manual De Instalación página 4

Installation
Configure Terminal Emulation Program: Open a VT100-compatible
3-2
terminal emulation program (such as the HyperTerminal program bundled
with Microsoft
port. (A notebook computer may be the most convenient choice.) Set the
terminal emulation program to use the COM
port that corresponds to the DB9 serial port.
A
Specify the parameters
communicate with the SNMPWEBCARD
terminal interface:
If the terminal emulation program supports multiple emulation modes, you
may also need to specify VT100 emulation
Note: The following message will appear in the terminal startup menu:
IAM:Got AUTO-CONFIGURED IPv6 address FE80::4200:FF:FE01:8 on interface
eth0:3
IPv6 is not currently supported. Tripp Lite is working on IPv6 for a future
release.
A
200907010 93-2916.indb 4
Windows ) on a computer with an available DB9 serial
® ®
required to
B
Bits per second:
Data bits:
Parity:
Stop bits:
Flow control:
.
C
B
4
9600
8
None
1
None
C
10/8/2009 5:16:37 PM