Tripp-Lite SNMPWEBCARD Manual De Instalación página 6

Installation
Follow the sequence of responses below in order to assign an IP address to
the card. The default terminal mode password is TrippLite. Sample IP
settings are shown - supply your own IP information when you configure
your card.
This card's hostname [ ]?
This card's domain [ ]?
Obtain IP settings automatically using DHCP for Ethernet interface? [Y]
IP address?
Subnet mask?
Gateway address?
DNS server 1?
DNS server 2?
This cards host name? [cornflakes]
This cards domain? [tlsoftwaredev.local]
SNMP Settings
Enable SNMP Community 0 [Y]? y
Choose a community privilege level:
Privilege Level [4]:
Community Name [tripplite]:
Allowable Address Range : [0.0.0.0]?
Allowable Address Mask : [0.0.0.0]?
Enable SNMP Community 1 [N]? n
Enable SNMP Community 2 [N]? n
Enable SNMP Community 3 [N]? n
Note: Default SNMP access is:
Community 0 enable with v2 read only community public
Community 1 enable with v2 read/write community tripplite
200907010 93-2916.indb 6
[10.2.0.98]
[255.0.0.0]
[10.0.0.1]
[10.0.0.5]
[10.2.0.10]
0 - noAccess
1 - v1UserReadOnly
2 - v1UserReadWrite
3 - v2cUserReadOnly
4 - v2cUserReadWrite
6
10/8/2009 5:16:38 PM