Tripp-Lite SNMPWEBCARD Manual De Instalación página 5

Installation
Insert SNMPWEBCARD in Accessory Slot: Use a screwdriver to remove
3-3
the accessory slot cover from the UPS. While the UPS is turned on, align the
SNMPWEBCARD with the guides in the accessory slot and push the card
into the slot until the ports are nearly even with the rear surface of the UPS.
Connect SNMPWEBCARD to Computer: Use the mini-DIN to DB9
3-4
serial cable (part number 73-1025) included with the card to connect the
card to the computer. The circular connector
attaches to the 8-pin mini-DIN serial port
connector carefully to avoid damaging the pins.) The DB9 connector
the other end of the cable connects to the computer's serial port
A
B
Connect SNMPWEBCARD to Network: Connect a standard Ethernet
3-5
patch cable to the RJ-45 Ethernet port on the card. Note: This port does not
support PoE (Power over Ethernet) applications.
Configure SNMPWEBCARD in Terminal Mode: After a brief pause, an
3-6
initialization page should appear in the terminal emulation program. Press
any key on the keyboard within 5 seconds to change the card's settings. (If
the 5-second period has elapsed, you can reboot the card by removing it and
then re-seating it in the accessory slot.)
200907010 93-2916.indb 5
at one end of the cable
A
on the card. (Align the
B
D
C
5
at
C
.
D
10/8/2009 5:16:38 PM