Cooper Lighting Lumiere Monaco 3000 Instrucciones De Instalación página 3

Box 2 Contents - Internal Components
1. Lamp housing assembly.
2. Ballast (electronic or magnetic) and driver assemblies.
3. Glass and gasket. (Figure 2.)
4. Trim ring (round or square).
5. Optional TRL lens.
Lamp Housing
Assembly
HID Electronic
HID Magnetic
Ballast
Ballast
Glass and Gasket
Figure 2.
TRL-3 (for T3.5, T4,T6, PAR20
Lamping Options)
TRL-38 (for PAR30
Lamping Options)
LED Driver
Trim Ring
(Round or Square)
COOPER LIGHTING SOLUTIONS
Installation Instructions – Monaco 3000
BUCKET INSTALLATION
CAUTION
To prevent water, dirt and debris from collecting,
install fixture to allow run off. Do not install fixture in
areas where water can collect for long periods of time.
Appropriate drainage must be provided.
Excavated hole must be approximately 15" in diameter by
20" in depth. Fixture must be installed with a minimum 4"
depth of pea gravel or equivalent drainage base. Backfill an
additional 8" depth of pea gravel on lower portion of fixture
for soil stability.
1. Dig Hole
3"
For Reference See "Installation Application. "
Figure 3.
Keep recessed screw locations clear of debris. This will help
to ensure complete seal.
IB526101EN
For Stability
Backfill Hole With
Gravel or Soil. Do
Not Backfill With
Sand or Bark.
Installation instructions
3