AREX Pro-care Optima Manual Del Instrucciones página 10

Pro-care Optima / English
5. Alarms and alarm mute key
When there is an alert situation happened, the LCD screen will display a corresponding error
code with an audible buzzer in an interval of a few seconds. The buzzer can be temporarily
suspended by pressing the Alarm Mute key. Alarm buzzer will signal repeatedly every 3 minute
until the alert situation is resolved.
Below presents 2 types of alarm and please refer to the attached error code table for details.
5.1 For issues that can be checked and solved by user, such as low pressure alarm in head, body
and foot areas, there'll be corresponding image. (see the table below)
Low Pressure Alarm
Alarm will be indicated when the pump detects low pressure condition within the mattress.
NOTE
- Under the alternating mode, for patient support, the system will first inflate and
hold the cells with the right pressure level, keep monitoring the cells with low pressure
condition. The system will remain in this state until the low pressure condition in the air
cells is solved.
NOTE- The pump can seal the air inside the mattress, which temporaily keeps the patients
from bottoming out during low pressure condition. Patient should be moved if the power
failure issue cannot be solved soon.
Low battery volume
NOTE- When low battery volume image is shown on the display, plug the power cord into
the wall outlet immediately.
CAUTION- Pump system will stop running but display the alarm image and buzzer when low
battery volume <10% is detected. To restore the system to the operating mode, plug
the power cord into the wall outlet, and press the power key to restart the pump.
Code No.
01 、 02 、 05
03 、 04 、 06
07
Diagram
Low pressure alarm: body section
Low pressure alarm: head section
Description
Low pressure alarm: foot section
8