Prepare The Location; Prepare Range Hood - Samsung LIB0168579 Guía De Instrucciones Para Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions
WARNING
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL THE RANGE
HOOD. FAILURE TO DO SO CAN RESULT IN BACK OR OTHER
INJURY.
NOTE
Mark the Range Hood knockouts on the wall and make the
necessary cutouts before installing the hood.

Prepare the location

A
1. If cabinet has recessed bottom, add wood filler strips on each side.
Install 4 flat head wood scretws with washers and nuts to attach filler
strips in locations shown.
NOTE
For installations to a surface other than drywall, it is recommended that a
qualified contractor determine the anchoring method.
2. Remove the grease filter by pulling the filter latch toward the back of
the range hood and using a Torx T10 adapter, remove the screw from
the filter retainer.
A
3. Remove the lateral panels by pulling them horizontally to the back of the
hood and then release the brackets on the front.
A
4. Using 2 or more people, lift the range hood up under cabinet and
determine final location by centering beneath cabinet. Mark on the
underside of cabinet the location of the 4 keyhole mounting slots on
the range hood (A) NOTE: Mark the thin area of the slot. On the back
wall mark the wholes for the security screws (B). Set range hood
aside on a covered surface.
8
English
Wood filler strips
(recessed cabinet
bottoms only)
Cabinet
bottom
A
A
A. Keyhole slot
5. Use
" (3 mm) drill bit and drill 4 pilot holes. NOTE: Make the drill
1
8
holes on the thin area of the slot.
6. Install the 4 - .45 cm x 1.3 cm mounting screws in pilot holes. Leave
about ¼" (6.4 mm) space between screw heads and cabinet to slide
A
range hood into place
Wall
7. Use
" (8mm) drill bit and drill 2 pilot holes in the marks for the secu-
8
25
rity screws, then place the drywall anchors.

Prepare Range Hood

1. Set the range hood on its back on a covered surface.
2. Using a flat-blade screwdriver, remove the appropriate power supply
knockout.
B
A
A. Drill pilot hole
"
1
4
(6.4 mm)

Publicidad

Tabla de contenido
loading

Tabla de contenido