Product Specifications - GBC ULTIMA 35 Guia De Inicio Rapido

Ocultar thumbs Ver también para ULTIMA 35:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21

Product Specifications

Model: Ultima 35
Operating Speed: Variable
Warm-up Time: < 2 min
Film Thickness Supported: 38-125mic
Maximum Film Width: 305mm
Document Widths Supported: Maximum - 292mm
Media Weight: 65-220 GSM
Dimensions:
Machine:
Width = 493mm
Height = 290mm
Depth = 427mm
Weight = 18.1kgs
Auto Shut Off: 60 minutes of inactivity
Fuse: Yes (internal & non-replaceable)
Operating Environment: 41 – 95 (F) / 5 – 35 (C),
Maximum Altitude of 2,000m
Installation
Service
WARNING: Do not attempt to service or repair the
laminator. Failure to observe this warning could
result in severe personal injury or death.
Disconnect the plug from the receptacle and contact
Customer Service when one or more of the following
has occurred.
• The power supply cord or attachment plug is
damaged.
• Liquid has been spilled into the laminator.
• The laminator is malfunctioning after being
mishandled.
• The laminator does not operate as described in
these instructions.
Installation
• Shipping damage should be brought to the
immediate attention of the delivering carrier.
• Place the laminator on a stable flat surface or
table capable of supporting 35kgs.
• The surface should be at least 80cm high
to assure comfortable positioning during
operation. All four rubber feet should be on the
supporting surface.
Shipping:
Width = 579mm
Height = 381mm
Depth = 533mm
Weight = 20.1kgs
• Connect power cord to an appropriate power
source. Avoid connecting other equipment to
the same branch circuit to which the laminator
is connected as this may cause nuisance
tripping of the circuit breaker or blown fuses.
• The laminator should be positioned to allow
exiting film to drop freely to a flat surface.
Accumulation of laminated documents as they
exit the laminator may cause a jam.
• Avoid placing laminator near sources of heat or
cold. Avoid locating the laminator in the direct
path of forced, heated or cooled air.
Caring for Ultima 35
The only maintenance required by the operator
is to periodically clean the heatshoe. This can be
done by waiting for the machine to cool completely
and then wiping the heatshoe with a damp, lint free
cloth. Keeping the heatshoe clean ensures that
your finished items will not be damaged by dirt and
adhesive build-ups.
WARNING: Do not apply cleaning fluids or
solvents to the heatshoes or rollers.
WARNING: Do not attempt to laminate
adhesives marked 'Flammable'.
WARNING: Do not expose laminator to
liquids.
1. Remove the film from the laminator following
the procedure outlined in the section FILM
LOADING AND THREADING.
2. Clean the heatshoe with a clean, damp, lint-free
cloth. If there are any adhesive build-ups, you
may use isopropyl alcohol instead of water.
3. Follow the procedure in section FILM LOADING
AND THREADING, Method Using Film
Threading Card to reload the laminator.
Note: Do not use metal scouring pads to clean the
heatshoe!
WARNING: Do not laminate glitter and/or
metallic items. Damage to the heatshoe may
result.
The side covers and feed table can be cleaned with
a lint-free cloth and a mild detergent.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido