Oregon Scientific RMR132HG Manual Del Usuario página 7

HOW TO CHECK REMOTE AND INDOOR
TEMPERATURE & HUMIDITY
Display of readings from a remote sensor or the main unit is a 1-
step procedure. The remote sensor channel or the main unit display
is indicated in a box under the kinetic-wave icon.
Kinetic-wave
Icon
Indoor
Designated
Display Display
To display temperature / humidity readings from the main unit:
• Press IN/CHANNEL until a dot is displayed in the box under
the kinetic-wave.
To display temperature / humidity readings from a remote
sensor:
• Press CHANNEL until the appropriate remote sensor channel
is displayed in the box under the kinetic-wave.
If no readings are received form one particular channel for more
than 15 minutes, blanks " --- " will be displayed until further
readings are successfully searched. Check the remote sensor to
ensure that it is secure and that the correct channel has been selected.
Optionally, press and hold IN/CHANNEL & [MEMORY] for 2-
seconds to enforce a search.
Remote Remote
Remote
Display
Display Display
Channel Two
Channel One Channel Three
HOW TO READ THE
KINETIC WAVE DISPLAY
The kinetic wave display shows the signal receiving status of the
main unit. There are three possible forms:
The unit is in searching mode.
Transmission data are securely
registered.
No signals.
THE COMFORT-LEVEL ICONS
The comfort level is based on the recorded relative humidity. An
indicator will be displayed or show if the level is comfortable, wet
or dry.
Comfort-level
Comfort
7
Dry Wet