Wireless Communication - Nacon REVOLUTION Unlimited Pro Controller Manual De Instrucciones

EN /
NOTES:
- The 'Mode Selection' switch on the back determines if the controller is working
in PS4™ Normal Mode (Position 1) or PS4™ Advanced Mode (Position 2).
- The PC Advanced Mode (Position 3) allows to switch your controller into the
X-Input Mode for PC* use.
b.

Wireless communication

Ensure that the wireless communication mode is selected and follow these
steps:
- Connect the USB Bluetooth
- The receiver LED will flash to show that it is searching for a controller.
- Press the PS button on your controller. The LED player status indicator will
light up. Please note the player status indicator can react to in-game action, if
supported by the software.
- The receiver LED will stop flashing when connected to the controller and will
display the same colour as the LED player status indicator on the controller.
- You are now ready to play.
I Multi player mode
When playing with 2 controllers there can be some interference between them.
If you experience some problems, during your gaming session, we recommend
you to check these different points:
- Ensure that you are at least 60 cm apart from the next player.
- Ensure than you are not too far away from your wireless receiver. We recommend
you to be at less than 5 meters for your multi player session.
- Ensure than the antenna of each wireless receiver is angled in a different
direction.
Note: In rare situations the signal can affect, or be affected by, other wireless devices such as WiFi routers,
WiFi repeaters or other Bluetooth products.
receiver into a free USB port on PS4™ system.
®