How To Use - BLACK&DECKER Home CM2070B Manual De Instrucciones

How to Use

This product is for household use only.
GETTING STARTED
• Remove all packing material and any stickers from product.
• Remove and save literature.
• Please go to www.prodprotect.com/applica to register your warranty.
• Wash all removable parts as instructed in CARE AND CLEANING section of
this manual.
• Open one-piece cover and insert permanent gold tone
filter or empty paper filter into removable filter basket
(C).
C
• Pour fresh cold water up to 12-cup (MAX) mark into the
D
water reservoir (D).
• Close one-piece cover.
• Place empty carafe on "Keep Hot" carafe plate.
• Pull power cord out from power cord holder in back of
coffeemaker and plug into standard electrical outlet.
• Brew water through appliance following BREWING COFFEE instructions,
without adding coffee grounds.
Note: This removes any dust or residue that may remain in system during
manufacturing process.
• Discard water from carafe and paper filter, if used, from filter basket.
• Turn off coffeemaker, unplug and allow to cool down.
ADJUSTING POWER CORD LENGTH
Tip: You can adjust length of power cord to suit your needs.
1. To increase length of power cord, simply grasp cord (not plug) in rear of
coffeemaker and gently pull down and out of slot away from coffeemaker.
2. To decrease length of power cord, simply feed any excess cord into slot in rear
of coffeemaker.
SETTING THE CLOCK
1. Plug appliance into standard electrical outlet.
2. Digital clock display flashes 12:00 (E).
Note: You must set display clock in order to use
Delayed Brewing feature.
E
6
3. To change time, press HOUR button until correct
F
time appears (F).
Note: When the time passes noon, a small icon
appears in the top left corner of the digital display
to let you know you are in PM time. If PM indicator
is not illuminated, the time is AM.
4. Repeat with the MINUTE (MIN) button (G).
G
Tip: Hold buttons down to make hours and minutes
change rapidly after a short delay. To change the
time in 1-digit increments, press and release the
buttons.
Note: If coffeemaker is unplugged or power is
interrupted even momentarily, display time may
need to be reset.
BREWING COFFEE
Note: It is not necessary to set the clock to brew coffee unless you want to
use Delayed Brewing feature.
1. Open the one-piece cover.
2. Fill water reservoir with desired amount of cold tap
H
water using water markings on front of reservoir.
Do not exceed 12-cup (MAX) level (H).
Important: There is an overflow opening at the back
of the coffeemaker. Be careful not to overfill the
water reservoir to avoid leaking onto the counter or
work surface.
3. Place permanent gold tone filter or basket-style paper filter into the
removable filter basket.
4. Add desired amount of ground coffee.
5. Insert filter basket into filter basket holder.
6. Close the one-piece cover.
7. Place empty carafe on "Keep Hot" carafe plate.
8. Plug cord into standard electrical outlet.
9. Press power ON/OFF button; POWER indicator
J
light is illuminated. Brewing begins OR, to delay
brewing, set auto function before pressing the
ON/OFF button (see DELAYED BREWING) (J).
10. Select the brew strength desired by pressing the
BREW STRENGTH button and selecting one of
the 2 levels desired:
• REGULAR
• STRONG
Note: The Brew Strength can be selected before or after brewing begins.
11. When coffee stops flowing into carafe, brew cycle is complete.
7