Cleaning the shaver
1
Insert the appliance plug.
1
2
2
Plug in the adaptor.
•
Remove any soap or water on the
shaver if it has been washed with hand
soap or any other detergent.
3
3
Remove the protective cap
and then attach the shaver.
•
Turn the shaver off before attaching.
•
Check that the outer foil is not deformed
or damaged when you are attaching the
shaver.
4
4
Press [SELECT] to select
the course.
•
The "Charge" course starts when
attaching the shaver.
•
Each time you press [SELECT], the
course changes from "Clean/Dry/
Charge"
"Dry/Charge"
•
The courses start approximately 6 seconds after they are
selected.
•
The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
•
Do not detach the detergent cartridge or the water tank as
the cleaning liquid may spill causing a malfunction.
2
1
3
"Charge".
Course
Course
selection
indications
Charge
Clean/Dry/
Charge
Dry/Charge
Time required (guide)
[In the low
temperature]
Charge (0 to 60 min)
Clean (10 min)
Dry (80 min [170 min])
Charge (0 to 60 min)
Dry (180 min)
Charge (0 to 60 min)
9
GB