Bissell POWERGLIDE LIFT-OFF PET PLUS 2043 Serie Guía Del Usario página 9

Replace Belt & Brush
1
Unplug vacuum, turn over and
unscrew 8 Silver Phillips head
screws to remove bottom cover.
3
Inspect brush roll by placing
it on its end and spin. The
brush roll should spin freely,
multiple times by one flick. If
it doesn't, replace brush roll.
Inspect belt, replace if it
appears damaged.
5
Pinch belt around brush
roll & hook back around
the silver motor gear.
Maintain the Pet TurboEraser® Tool
1
3
To reassemble, align two
clips on each end of paddle
wheel with belt on and pop
back into place.
Replace brush roll with belt,
making sure all parts are
aligned correctly.
6
Rotate brush roll into place
and line up end caps.
Twist gray collar
counter-clockwise,
until slot appears,
and then separate
faceplate.
2
4
2
Paddle Wheel
Belt
Roller
4
Pull roller straight
out and slide belt
off brush roll and
motor gear.
Place belt back
on brush roll.
7
Re-attach bottom
cover with 8 screws.
Remove brush roll,
belt, and paddle
wheel. Inspect
for damages and
replace if necessary.
To put faceplate
back on, align the
tabs in the top
of the cover and
place it down to
"click" into place.
www.BISSELL.com
9