Xerox Phaser 5335 Guia De Instalacion página 3

4. Loosen the three screws that secure the
metal plate cover inside the printer.
5. Pull the metal plate cover forward and
remove it from the printer.
6. Insert the connector on the hard disk into
the connector on the printer (located at the
right of the controller board).
Important
• The connector at the left of the controller board is for a
network expansion card (optional). Do not insert the
hard disk into this connector.
7. Press the hard disk as shown in the figure
and firmly insert it into the connector.
8. Hand-tighten the two screws (supplied)
from the outside of the printer and secure
the hard disk onto the controller board.
Hard disk connector
3