Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION
The LG 2279 unit is an electronic board for the automation of doors, windows and gates with the help of 24VDC electro-
mechanic actuators.
BLOCK DIAGRAM OF EQUIPMENT
F1 = 2A fuse for 230 V power supply
F2 = 10A fuse for 24 V power supply
J1 = Control and drive terminal board
J2 = 230 V power supply terminal board
TF1 = Transformer
RL1-RL2 = Open/close switch relay
RL3 = Drive priority management relay
DB1 = 10 A rectifier bridge
Electronic Board dimension = 12,2 x 11 x 5 cm.
Plastic Box dimension = 15 x 20 x 8 cm.
LG 2279 TERMINAL BOARD DESCRIPTION
1 Terminals 1 and 2: power supply for the
actuators. Connection for supplying power to
24Vdc actuators with maximum absorption of
8A.
2 Terminals 3, 4 and 5: open/close command
(local). Contact for commanding opening and
closing of the actuator. The operation of this
contact has priority over terminals 6, 7 and 8.
3 Terminals 6, 7 and 8: open/close command
(local). Contact for commanding opening and
closing of the actuator without any priority.
When the centralised contact is enabled, every
function is disabled and is re-enabled only
when the centralised contact is in the rest
position.
4 Terminals N and L : 230 V, 50 Hz power
supply.
L = PHASE
N = NEUTRAL
Attention :
Connect the Rain Sensor to either " 4 and 5 "
or to " 3 and 4 " as required, making sure that
the "emergency rain" gives always the closing
command.
Publicidad
