Removing The Unit - Kenwood DPX395MBT Manual De Instrucciones

Installation/Connection
Installing in Toyota cars
(For )
Install onto the car brackets using screws (E) or (F) (supplied). Use the
mounting holes ( ) or ( ) that fit the car brackets. Then, install the
supplied trim plate (C).
Do the required wiring.
(Page 31)
Dashboard of your car
* Only for illustration purpose.
30
ENGLISH
Car bracket*
Installing the unit (without mounting sleeve)
Align the holes in the unit (on both sides) with the vehicle mounting
bracket and secure the unit with supplied screws.
• For : Remove the mounting sleeve and trim plate from the
unit before installing.
Use only the specified screws. Using wrong screws might damage the
unit.

Removing the unit

(For )
1 Fit the catch pin on the extraction keys into the holes on both sides of
the trim plate, then pull it out.
2
Insert the extraction keys deeply into the slots on each side, then
follow the arrows as shown on the illustration.