Sauder 408995 Manual Del Usuario página 20

Step 15
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (I) to the LEFT END (B). Use the screws
å
in the HINGE (GG2). You should start each SCREW a few
turns before completely tightening any of them.
Peel the FELT DISCS from the FELT DISC CARD (PP).
å
Stick a FELT DISC on the DOOR where it comes in
contact with the UPRIGHT (C).
Fasten a KNOB (MM) to the DOOR (I). Use a BLACK 7/8"
å
MACHINE SCREW (TT).
See the next step for DOOR adjustments.
å
MM
PP
Page 20
GG2
B
I
BLACK 7/8" MACHINE SCREW
(1 used for the KNOB)
C
TT
408995
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
GG2
Mounting
screw
Hinge
www.sauder.com/services