Publicidad
Step 19
1
D28
M
Groove
Insert the DRAWER SIDES (D28 and D29) at an angle
å
into the slot at each end of the DRAWER FRONT (M).
3
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D28 and D29). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D707) inserts into the groove of the DRAWER BACK (D78).
å
Page 24
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D29
D78
D28
D707
VIEW THE T-LOCK BOX VIDEO
2
D28
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D707) into the grooves in the
å
DRAWER SIDES (D28 and D29) and DRAWER FRONT (M).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D29
408995
With the palm of
your hand, tap the
DRAWER BOTTOM
U n
down into the groove.
fi n
s u
i s h
r f a
e d
c e
D707
D29
M
30S
(4 used in this step)
www.sauder.com/services
Publicidad
