SPORTSTECH CX608 Manual Del Usuario página 29

12
14
15
13
20
19
62
61
15
9
5. Handlebar and Computer Installation
Remove two M8x15 Bolts (20) ,two Ø10xØ20x1.5 pvc washer(62) and two Ø8xØ16x1.5 Curve Washers (19) from
the Front Post (8).
Insert the Hand Pulse Sensor Wires (15) from the Handlebar (9) into the hole on the Front Post (8) and then pull them
out from the top end of the Front Post (8). Attach the Handlebar (9) onto the Front Post (8) with two M8x15 Bolts
(20) ,two Ø10xØ20x1.5 pvc washer(62) and two Ø8xØ16x1.5 Curve Washers (19) that were removed. Tighten
bolts and curve washers with the S6 Allen Wrench provided. Remove four M5x10 Bolts (13) from the back of the
Computer (12). Remove bolts with the Multi Hex Tool with Phillips Screwdriver provided.
Connect the Sensor Wire I (14) and Hand Pulse Sensor Wires (15) to the wires that come from the Computer (12)
and then attach the Computer (12) onto the top end of the Front Post (8) with four M5x10 Bolts (13) that were
removed. Tighten bolts with the Multi Hex Tool with Phillips Screwdriver provided.
29