Fagor 8H-755BB Manual De Instrucciones página 48

OPERATION
time, wait 10 seconds to save the current
setting and the appliance will enter standby.
Press the touch sensor to set the beep
tone. The clock operates in 24h mode only.
Night Mode
During 22:00 – 06:00 in standby the display
backlight is reduced as set for night-time
mode - 2 levels below the current setting.
Change the beep tone
This function is available at any time in
standby mode. When setting current time,
press the touch sensor to display ton1,
where 1 is the current beep tone – tones 1
through 3 are available. Turn the +/– knob
to change the current tone, then wait 5 sec-
onds to confirm the new setting and the ap-
pliance will enter the standby mode.
Adjust display brightness
This function is available at any time in
standby mode. When selecting tone, press
the touch sensor again to change dis-
play brightness and bri4 (brightness 4) will
be shown where 4 is the brightness level
from 1 to 9. Turn the +/– knob to change the
brightness, then wait 5 seconds to confirm
the new setting and the appliance will enter
the standby mode.
Operation
You can use any baking or cleaning function
available on the Function Selector knob.
Auto-off: When minute minder or any timed
delayed, timed or cleaning programme is
completed, the appliance enters the standby
mode even if the function selector knob is
set to 0.
48
Lighting
The appliance automatically controls oven
light. By default the oven light is on.
The oven light is off:
- when 0, Pyrolytic cleaning or ECO is se-
lected;
- when the oven cavity temperature exceeds
300°C;
- during pyrolytic cleaning and cooling;
- before and after the timed and timed de-
layed operation;
- in standby mode, if the Function Selector
knob is set to a position other than 0.
Cooling fan.
Cooling fan operates independently of the
set functions and the appliance mode of op-
eration. Cooling fan turns on when the oven
cavity temperature exceeds 80°C and turns
off when it fall below is below 75°C.
Thermostat
The thermostat symbol
heating elements operate. If any of the heat-
ing elements operates, the indicator lights
up. The indicator goes out, if none of the
heating elements operates (e.g. when the
oven reaches the desired temperature and
the heating elements are disconnected until
the temperature drops).
Minute Minder
Touch the touch sensor in any mode
to use minute minder. Press
countdown progress or 0.00 if minute mind-
er is not active, the
Turn the +/– knob to adjust the Duration and
press to confirm or simply wait 5 sec-
onds.
When the minute minder is counting down,
indicates that the
to display
indicator will flash.