Troubleshooting Guide; Français - Braun TexStyle 9 SI 9187 E Manual De Instrucciones

by insufficient aftercare or cleaning:
or damage caused by the chemical or
electrochemical effects of water.
Under no circumstances shall the appli-
cation of this guarantee give rise to the
complete replacement of the appliance

Troubleshooting Guide

PROBLEM
Water droplets drip on the
fabric during ironing.
Water droplets drip from the
soleplate after the iron has
been unplugged or has been
stored.
The iron produces little or no
steam.
Flakes and white impurities
come out during ironing.
The spray function or the
steam shot do not work
properly.
The LED turns permanently
on.
Français
Avant utilisation
Lisez attentivement toutes les instructions
avant d'utiliser l'appareil.
Attention : A cause de la haute
performance de cette centrale
vapeur, veuillez vous assurer que
votre réseau électrique est adapté.
Veuillez contacter votre compagnie
électrique pour s'assurer que
l'impédance n'est pas supérieure à
0.350 Ohm.
Description
1 Buse du spray
POSSIBLECAUSES
The water tank lid is not properly
closed.
Chemicals have been put into the
water tank.
The steam trigger is overused.
The steam regulator is set beyond
"0" level.
You have put the iron in horizontal
position with water inside the tank.
The water tank is empty.
The valve has collected too much
scale.
The iron is not hot enough to
produce steam.
The iron has limescale formations
inside the steam chamber.
The water tank is empty.
There is a problem with tempera-
ture probe.
or entitle the consumer to damages.
Braun Household, New Lane, Havant,
Hampshire PO9 2NH
www.braunhousehold.co.uk
Subject to change without notice.
SOLUTION
Press the water tank lid and check if it
is closed.
Never put chemicals or perfumes into
the water tank. Empty the water tank,
rinse it 2-3 times.
Wait at least a few seconds between
each use.
Set the steam regulator to "0".
Empty the water tank after ironing and
place the iron vertically on a stable
surface during the cooling down.
Refill the water tank.
Clean the valve.
Wait until the iron heats up and the
temperature control LED is
permanently on.
Run the descaling procedure (clean
the steam chamber and the valve).
Refill the water tank.
Unplug and plug in again. If the
problem does not disappear contact
the Braun customer service.
2 Couvercle du réservoir d'eau
3 Bouton du spray
4 Régulateur de la vapeur
5 Bouton vapeur turbo
6 Gâchette de jet de vapeur
7 DEL de contrôle de la température
8 Cordon d'alimentation
9 Talon d'appui
10 Semelle 3D
(A) Début du repassage
Remplissage du réservoir d'eau.
• Assurez-vous que l'appareil est éteint et
débranché.
• Remplissez le réservoir d'eau avec de
l'eau du robinet en maintenant le fer à
repasser légèrement incliné et en prenant
soin de ne pas dépasser le niveau « max ».
Si la dureté de votre eau est extrêmement
élevée, nous vous recommandons
11