One for All URC-4912 Manual De Instrucciones página 4

STEP 2: IF STEP 1 DOES NOT WORK AS EXPECTED
ARE SOME KEYS NOT WORKING AS EXPECTED?
If you find some keys do not work as expected (or at all), proceed to the next
step.
1.
Make sure your TV is on (not on standby).
2.
3.
4.
The remote will send a signal every 3 seconds.
5.
When the correct function is shown on the screen (in this case the HOME),
let go of the key.
6.
The LED will blink twice - your remote is ready to use.
LEARNING
LEARN A NEW FUNCTION TO YOUR REMOTE
Your One For All remote can learn any function from your original (working)
remote.
1.
Place the original remote facing the One For All remote on a flat surface.
2.
3. Press 975. The LED will blink twice.
4.
Press the key on the One For All remote you want to learn on,
for Example: the VOL + key. The LED will blink rapidly.
5.
Press the key on the Original remote you want to learn, for
Example: the VOL + key of your Audio Device
6. Two blinks: ok. Repeat from step 4 for any more keys to learn.
Long blink: try again from step 4.
7.
When you have learned all the keys you need, press and hold
the OK key for 3 seconds. The LED will blink twice.
HOW TO DELETE A LEARNED FUNCTION
1. Hold down GREEN + YELLOW until the LED blinks twice.
2. Press 976.
3.
Press the key to reset twice.
4. The LED flashes twice and the key will revert to the original function.
4
ENGLISH
Hold down RED + BLUE until the LED behind the
Power Key blinks twice
Point towards the TV and hold one of the keys that is
not working correctly (for example HOME).
To learn: Hold down GREEN + YELLOW until the LED
blinks twice.
CH
2 - 5 CM