Electrical connection
CAUTION
Electrical connections may only be carried out by qualified,
skilled personnel trained in the applicable health and safety
regulations of the relevant country.
WARNING
Dangerous electrical voltages!
It is imperative to deactivate the power supply during wiring of
the device.
CAUTION
During the terminal box assembly pay attention to not damage
the O-ring gasket (fig.4/7). If it happens, substitute the gasket.
T Type
Unscrew the n.3 screws of the cover of the micro-switches.
Insert the multi-polar cable through the cable gland
(remove it if necessary) and make the connection on the
terminal box of the micro-switches.
Figure C
6
M Type
Remove the duct cover (fig.B/9) unscrewing the 4 screws
(fig.B/11). Insert the multi-polar cable through the cable
gland (remove it if necessary) and make the connection on
the terminal box with the relevant electric diagram (fig.C
e fig.D)
1
2
A
B
SW1
C
D
E
Figure D
F
1
2
Figure E
PRESSURE RELIEF DEVICES TYPE T & M
3
4
5
CREATED BY
Diego Boro
APPROVED ON
-
COMPANY
COMEM
RESPONSIBLE DEPARTMENT
ITABB-9AAE306693
3
4
5
6
SW2
SW3
REVIEWED BY
-
DOCUMENT KIND
Component Drawing
TITLE / SUPPLEMENTARY TITLE
COMEM LPT PER CATAL
-
DOCUMENT ID
NV-402
© COPYRIGHT ALL RIG
6