Remove The Unit; Install The Unit (Din Rear Mount), Install And Remove The Front Panel - Multilaser explorer Manual Del Usuario

Remove the unit

Frame
1.
Insert fingers into the groove in the front of frame and
2.
pull out to remove the frame (When reattaching the frame, point the
side with a groove downwards and attach it.).

Install the unit (DIN rear mount), install and remove the front panel

50
Lever
3.
Insert the levers supplied with the unit into the grooves at both
sides of the unit as shown in figure until they click. Pulling the levers
makes possible to remove the unit from the dashboard.
Installation using the screw holes on the sides of the unit. Fastening the unit
to the factory radio mounting brackete.
Select a position where the screw holes of the bracket and the
1.
screw holes of the main unit become aligned (are fitted) and tighten the screws at
2 places on each side. Use either truss screws (5x5 mm) or flush surface screw
(4x5 mm).
Screw ("T" Position).
2.
Dashboard or Console.
3.
NOTE:
The mounting box, outer trim ring, and half-sleeve are not used for method
B installation.