Bosch Weu PLR 50 C Manual Original página 38

OBJ_BUCH-2326-002.book Page 38 Friday, November 7, 2014 10:15 AM
38 | English
Digital Spirit Level
Press the k button and select the button for the digital spirit level
The digital spirit level is used to check the horizontal or vertical
alignment of an object (e.g. washing machine, refrigerator, etc.).
The rear of the measuring tool serves as the reference level for the
digital spirit level.
Continuous Measurement (Tracking) / Minimum/Maximum Measurement
(see figure D)
For continuous measurements, the measuring tool can be moved relative to the tar-
get, whereby the measuring value is updated approx. every 0.5 seconds. In this man-
ner, as an example, you can move a certain distance away from a wall, while the actual
distance can always be read.
Press the k button and select the button for continuous measurement
measuring button 1 to start the continuous measurement.
The minimum measurement is used to determine the shortest distance from a fixed
reference point. It is used, as an example, for determining plumb lines or horizontal
partitions.
The maximum measurement is used to determine the greatest distance from a fixed
reference point. It is used, as an example, for determining diagonals.
Continuous measurement automatically switches off after 5 mins. The last measured
value remains on the display.
List of the Last Measured Values/Calculations
The measuring tool stores the last 10 measured values and their calculations and dis-
plays them in reverse order (most recent measured value/most recent calculation
first).
Press the i button and select the p button.
2 609 141 217 | (7.11.14)
.
. Press the
Bosch Power Tools