Hilti HIT-HY 270 Manual De Instrucciones página 28

Hilti HIT-HY 270
Adhesive anchoring system for anchor fastenings.
Adhesive anchoring system for anchor fastenings in hollow and solid clay brick, sand-lime block, concrete,
concrete block, aerated concrete and natural stone.
Hilti HIT-HY 270
Contains: hydroxypropylmethacrylate(A), dibenzoyl peroxide(B)
Warning
H315
H317
H319
H410
H412
P262
P280
P302+P352
P305+P351+P338
P333+P313
P337+P313
Disposal considerations
Empty packs:
▶ Leave the mixer attached and dispose of via the local Green Dot recovery system
material code: 150102 plastic packaging
Full or partially emptied packs:
▶ Must be disposed of as special waste in accordance with official regulations.
EAK waste material code: 08 04 09* waste adhesives and sealants containing organic solvents or other
dangerous substances. or EAK waste material code: 20 01 27* paint, inks, adhesives and resins containing
dangerous substances.
Content: 330 ml / 11.1 fl.oz.
Hilti accepts no liability for damage or failure caused by:
– Storage and transport not in accordance with the specified conditions.
– Failure to observe the instructions for use and setting data, incorrect use
– Inadequate design of the anchor points, inadequate load bearing capacity of the base material
– Other influences of which Hilti is not aware or on which Hilti has no influence,
e.g. use with products from a third party.
28
Causes skin irritation.(A)
May cause an allergic skin reaction.(A,B)
Causes serious eye irritation.(A)
Very toxic to aquatic life with long lasting effects. (B)
Harmful to aquatic life with long lasting effects.(A)
Do not get in eyes, on skin, or on clothing.
Wear protective gloves/protective clothing/eye protection/face protection.
IF ON SKIN: Wash with plenty of soap and water.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact
lenses, if present and easy to do. Continue rinsing.
If skin irritation or rash occurs: Get medical advice/attention.
If eye irritation persists: Get medical advice/attention.
500 ml / 16.9 fl. oz Weight: 540 g/19.0 oz
or EAK waste
820 g/28.9 oz