Uline BROTHER P-TOUCH D400AD Manual Del Usuario página 2

POWER SUPPLY AND TAPE CASSETTE
Insert six new AA alkaline
batteries (LR6) or fully
charged Ni-MH batteries
(HR6), making sure that their
poles point in the correct
directions. To remove
the batteries, reverse the
installation procedure.
(See Figure 1)
NOTE: When using AC adapter (AD-E001):
• Insert the plug on the adapter cord into the AC
adapter jack on the side of the machine.
• Insert the plug into the nearest electrical outlet.
For memory backup, we recommend using AA
alkaline batteries (LR6) or Ni-MH batteries (HR6)
together when using the AC adapter.
WARNING! Using a combination of different batteries (such as Ni-MH and alkaline), may result in an
explosion. Dispose of used batteries according to the instructions.
INSERTING A TAPE CASSETTE
Figure 2
Tape Cutter Lever
Tape Compartment Cover
NOTE: When inserting the tape cassette,
make sure that the tape and ink ribbon do
not catch on the printhead. (See Figure 2)
PAGE 2 OF 27
SETUP
Battery Compartment
Cover
Printhead
Battery Case
• To safeguard and backup the printer's memory,
when the AC adapter is unplugged, it is
recommended to have AA alkaline batteries (LR6) or
Ni-MH batteries (HR6) installed in the printer.
• When power is disconnected for more than two
minutes, all text and format settings will be cleared.
Any text files stored in the memory will also be
cleared.
Tape Cassette
Compartment
Release Lever
Tape Cutter
Tape Exit Slot
• If you cannot close the tape compartment
cover, check to ensure the release lever in
the up position. If not, lift the lever and then
close the cover.
Figure 1
AC Adapter Jack
Keyboard
LCD Display
0721 IH-5135