Uline BROTHER P-TOUCH D400AD Manual Del Usuario página 6

SETTING MARGIN [FULL]/[HALF]/[NARROW]
➔ ▲/▼ [Margin] ➔ ▲/▼ [Full/Half/Narrow]
➔ ▲/▼ Select the number of copies ➔
or . (See Figure 7)
Full Half
0.94" 0.94"
(23.9 mm) (23.9 mm)
NOTE: Cut along the printed dots (:) with scissors
so the text is centered in the label.
[CHAIN]
Use this setting when printing several labels with minimal
margins. (See Figure 8)
Enter text (ABC) ➔
OK
or
➔ ➔
copies ➔ , or
OK
Feed?] appears ➔
Esc
for the next label (DEF) ➔
OK
of copies ➔ , or
Feed?] appears ➔
OK
Figure 8
NOTE: When [Chain] is set, feed the tape before
using the cutter otherwise a part of the text may
be cut off. Refer to "Feeding Tape" on page 3.
• The value XX displayed on the upper right corner of
the LCD display indicates the label length XX shown
on the label images below. (See Figure 9)
LCD Display
Figure 9
PAGE 6 OF 27
PRINTING A LABEL CONTINUED
Narrow
0.47" 0.47"
(12 mm) (12 mm)
➔ ▲/▼ [Margin] ➔ /
➔ ▲/▼ Select the number of
➔ The message [OK to
➔ Clear the text and enter text
➔ ▲/▼ Select the number
➔ The message [OK to
or to feed the tape.
0.37"
(9.5 mm)
Label Image
Full
XX" (XX mm)
Half
XX po (XX mm) XX" (XX mm)
Narrow
XX" (XX mm)
NOTE: Do not pull the tape, since this may
damage the tape cassette.
OK or
OK
,
ADJUSTING THE LABEL LENGTH
➔ ▲/▼ [Adjustment] ➔
Figure 7
[Label Length] ➔
NOTE: Approximately 1% of the total label
length will be adjusted by one level.
0.16" 0.16"
USING SAMPLE LABELS TO CREATE AND
(4 mm) (4 mm)
PRINT LABELS FROM PRE-DESIGNED
TEMPLATES
Example:
[Chain]
➔ ▲/▼
Move the cursor to the first line and edit the text ➔
the text ➔
of copies ➔
NOTE: When a sample label consists of two
lines of text, removing the second line also
removes the character attributes of the
second line.
• To recover the original character attributes of the
deleted second line, cancel the currently selected
sample label by pressing
sample label again.
• To delete all text at once on a line only, move the
cursor to the line you wish to delete all text, then
press
OK
or
/ [-5 - +5] ➔
OK or
➔
➔ Move the cursor to the second line and edit
➔ ▲/▼ Select the number
➔
, or .
OK
and .
Shift
➔ ▲/▼
OK
or .
➔ ➔
and select the same
0721 IH-5135