Enclosure Installation; Preparation; Unpacking - Tripp-Lite SmartRack SRQ18U Instrucciones De Funcionamiento Y Manual Del Propietario

Enclosure Installation

Caution! Read All Instructions and Warnings Before Installation!
WARNING: The rack enclosure is extremely heavy. Do not attempt to unpack, move or install the enclosure without assistance. Until it has
been properly installed and stabilized, the enclosure is prone to tipping and could cause property damage and/or personal injury. Use
extreme caution when handling the enclosure and be sure to follow all handling and installation instructions. Do not attempt to install
equipment without first stabilizing the enclosure.

Preparation

The enclosure must be installed in a structurally sound area with a level floor that is able to bear the weight of the enclosure, all the equipment that will be
installed in the enclosure and any other enclosures and/or equipment that will be installed nearby. Before unpacking the enclosure, you should transport the
shipping container closer to the final installation location to minimize the distance you will need to move the unit after the protective packaging has been
removed. If you plan to store the enclosure for an extended period before installation, follow the instructions in the Storage and Service section.
You need several tools (user-supplied):
• 13 mm Open-end Wrench
• 18 mm Open-end Wrench
• Utility Blade
• Carpenter's Level
• Phillips-head Screwdriver
• 5/32" Allen Wrench

Unpacking

1 Confirm the shipping container is upright and stable, then use a utility blade to cut the shrink-wrap
Apply the utility blade directly over one of the corners (a corner protector is located underneath the
cardboard packing materials) to prevent the utility blade from scratching the enclosure or cutting the
heavy protective plastic bag beneath the shrink-wrap. Cut and remove the plastic straps surrounding
. WARNING: Do not scratch the enclosure or cut the heavy plastic
the cardboard packaging
B
bag beneath the cardboard packaging. Do not push or pull the enclosure while unpacking.
2 Remove the cardboard packing materials covering the enclosure. Save all packing materials (including
the pallet) for later use unless you are certain they will not be required. The packing materials are
recyclable.
Remove the corner protectors
3
Examine the enclosure for any damage or loose parts. Confirm that all parts are present. If anything is
missing or damaged, contact Tripp Lite for assistance. Do not attempt to use the enclosure if it has
been damaged.
, then remove the heavy plastic bag surrounding the enclosure
A
You also need the following hardware (included):
• (60) Phillips-head Mounting Screws (M6 x 5/8")
• (60) Cage Nuts (M6)
• (60) Nylon Cup Washers
.
A
1
2
.
B
3
4
B
A
B
A