Operation; Specifications; Storage And Service - Tripp-Lite SmartRack SRQ18U Instrucciones De Funcionamiento Y Manual Del Propietario

Operation

The SRQ18U/SRQ24U uses two sets of vertically mounted fans to push warm air generated from equipment into the warm air chambers and side exhaust
panels.
Connect Fans to the Power Strip
Plug each fan unit into the power strip located on the bottom panel at the rear of the unit. The remaining outlets are available for plugging in accessories or
additional fan units (sold separately).
IMPORTANT: DO NOT OVERLOAD THE POWER STRIP. The power strip can accommodate a total equipment load up to 15A (whether plugged in to a
single outlet or spread out over multiple outlets). If the circuit breaker trips, outlets will cease to provide power. Reduce the load on the power
strip down to its 15A rating by unplugging excess equipment, then depress the circuit breaker button to reset.
Connect the Power Strip to an AC Power Line
Plug the power strip directly into a 3-wire grounded, 120V AC outlet.
Turn Power Switch ON
To provide power to the fans and any additional equipment, turn on the power switch.

Specifications

Load Capacity
Model Static
SRQ18U 750 lb.
(340 kg)
SRQ24U 1000 lb.
(453.5 kg)

Storage and Service

Storage
The enclosure should be stored in a controlled indoor environment, away from moisture, temperature extremes, flammable liquids and gasses, conductive
contaminants, dust and direct sunlight. Store the enclosure in its original shipping container if possible.
Service
Your Tripp Lite product is covered by the warranty described in this manual. A variety of Extended Warranty and On-Site Service Programs are also available from
Tripp Lite. For more information on service, visit www.tripplite.com/support. Before returning your product for service, follow these steps:
1. Review the installation and operation procedures in this manual to insure that the service problem does not originate from a misreading of the instructions.
2. If the problem continues, do not contact or return the product to the dealer. Instead, visit www.tripplite.com/support.
3. If the problem requires service, visit www.tripplite.com/support and click the Product Returns link. From here you can request a Returned Material
Authorization (RMA) number, which is required for service. This simple on-line form will ask for your unit's model and serial numbers, along with other general
purchaser information. The RMA number, along with shipping instructions will be emailed to you. Any damages (direct, indirect, special or consequential) to
the product incurred during shipment to Tripp Lite or an authorized Tripp Lite service center is not covered under warranty. Products shipped to Tripp Lite or
an authorized Tripp Lite service center must have transportation charges prepaid. Mark the RMA number on the outside of the package. If the product is
within its warranty period, enclose a copy of your sales receipt. Return the product for service using an insured carrier to the address given to you when you
request the RMA.
Unit Dimensions
Rolling Height Width
750 lb. 38.6 in. 30 in.
(340 kg) (978 mm) (762 mm)
1000 lb. 49 in. 30 in.
(453.5 kg) (1246 mm) (762 mm)
Depth Weight Height
46.7 in. 242 lb. 44 in.
(1186 mm) (110 kg) (1092 mm)
46.7 in. 297 lb. 54.4 in.
(1186 mm) (135 kg) (1379 mm)
8
Shipping Dimensions
Width Depth Weight
32 in. 48.7 in. 271 lb.
(813 mm) (1237 mm) (123 kg)
32 in. 48.7 in. 330 lb.
(812 mm) (1237 mm) (150 kg)