REED Rotary RC20 Manual De Instruccion página 4

LATCH
HANDLE
SADDLE
TORQUE ARM
9. Lift handle until latch slides up over one of the lugs, then pull
down on the handle to rotate the cutter.
10. After each half rotation, tighten one of black nuts on the cutter
with provided wrench, alternating between each nut. Tighten
the nuts as tight as possible each time. After one complete
rotation check to see if the cutter is tracking properly.
It is important to complete the cut without pausing and to
maintain consistent pressure.
For the RC30 and larger cutters, it may be advisable to have two
workers: one person tightens the nuts while the other person
rotates the cutter.
Fig. 6
LOCATION OF SADDLE
3-1/8 inches (79 mm)
From Center Of Cut Line
To Edge Of Saddle
Left arrow shows "center of cut line".
Right arrow shows "edge of saddle".
4
WRENCH
RC42 Parts Provided for Assembly
Cotter Pin & Washer Used to Secure Handle to
Latch (2 sets provided).
Parts lists for these cutters begin on page 8.
Fig. 7
USE THIS PIVOT HOLE FOR
42" (1063 mm) DIAMETER PIPE
USE THIS PIVOT HOLE FOR
40" (1020 mm) DIAMETER PIPE
2.5
inches
RC42 SCREW