3M 2100100 Manual Del Usuario página 12

5.0 INSPECTION
;
After product has been removed from service, it may not be returned to service until a Competent Person
confirms in writing that it is acceptable to do so.
5.1 INSPECTIoN FrEQUENCY: The Concrete Wedge Anchor must be inspected at the intervals defined in Section 1.
Inspection procedures are described in the "Inspection and Maintenance Log" (Table 2). Inspect all other components of
the Fall Protection System per the frequencies and procedures defined in the manufacturer's instructions.
;
Concrete Wedge Anchors are equipped with a Radio Frequency Identification (RFID) Tag. The RFID Tag can be used
in conjunction with a Handheld Reading Device to simplify inspection and inventory control and provide records for your
fall protection equipment.
5.2 dEFECTS: If inspection reveals an unsafe or defective condition, remove the Concrete Wedge Anchor from service
immediately and contact 3M regarding replacement or repair. Do not attempt to repair the Fall Arrest System.
5.3 ProdUCT LIFE: The functional life of the Fall Arrest System is determined by work conditions and maintenance. As long
as the product passes inspection criteria, it may remain in service.
6.0 MAINTENANCE, SERVICE, and STORAGE
6.1 CLEANING: Periodically clean the Concrete Wedge Anchor metal components with a soft brush, warm water, and a mild
soap solution. Ensure parts are thoroughly rinsed with clean water.
6.2 SErVICE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment. If the
Concrete Wedge Anchor has been subject to fall force or inspection reveals an unsafe or defective conditions, remove the
system from service and contact 3M regarding replacement or repair.
6.3 STorAGE ANd TrANSPorT: When not in use, store and transport the Concrete Wedge Anchor and associated fall
protection equipment in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may
exist. Thoroughly inspect components after extended storage.
7.0 LABELS and MARKINGS
Figure 11 illustrates labels on the Concrete Wedge Anchor. Labels must be replaced if they are not fully legible. Information
provided on each label is as follows:
Read all instructions.
1) Installation Dimensions 2) Installed Product 3) Manufacturer 4) Notified Body ID and Safety Standard
12