System Requirements; Preparing Fittings - Schell 00 503 00 99 Manual Para La Puesta En Servicio Y La Configuración

Sistema de gestión de agua
Ocultar thumbs Ver también para 00 503 00 99:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Commissioning

System requirements

In e isting buildings
drin ing
and can only be determined appro imately in most cases. This means that in
stallation areas can for instance be volumetrically measured and critical tem
peratures detected by measurements and compensated by stagnation ushes.
e basically recommend that the success of the selected settings for stagna
tion ushes is chec ed right from the start using temperature measurements
and microbiological tests.
In accordance
after being run for 30 seconds and arm ater at least 55 °C after 30 seconds.
After measurements of this ind, further measures to saving ater can also of
ten be successfully implemented and confirmed in terms of temperature and
microbiology (see above).
In almost all cases, a stagnation ush carried out for hygiene reasons needs less
drin ing
ushing is only carried out
to a ma imum of once every 7 days) and not several times a day. This means
that the eSCHELL
ance bet een saving
1.2 System requirements
The eSCHELL soft are required for the eSCHELL ater management system is
a bro ser based solution. ou do not need to do nload and install any soft
are, because the program is installed on the eSCHELL
server.
The connection
LAN or a LAN cable connected to the server.
The
cess the eSCHELL
bro ser (e.g. Internet E plorer, Google Chrome, Safari or Mozilla Firefo ) is
recommended.
1.3
Ma e sure that the lin ed fittings have
136
ithout corresponding documentation concerning the
ater installation, the programming parameters are more difficult
ith DIN 1 88 200, cold
ater than normal usage of the drin ing
ater management system also specifically enables the bal
ater and maintaining
ith the eSCHELL
eb bro ser of a PC, laptop or mobile terminal device is needed to ac
ater management system s data. Use of a current
reparin fittin s
ater must be less or equal to 25 °C
ith interruptions of use once every 72 hours (up
ater quality to be achieved.
ater management server is achieved via
ater and electrical connections.
ater installation, because
ater management
eb

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

00 502 00 9900 501 00 9900 506 00 9900 505 00 9900 500 00 99

Tabla de contenido