Cequent Performance Products 24810 Instrucciones De Instalación

Impact bar
Tow hook
Hitch Shown In Proper Position
Equipment Required: Sealant
Fastener Kit: 24810F
Wrenches: 3/4", Crowfoot adaptor
m k
Seal existing drain holes
in trunk pan to prevent
intrusion of exhaust
fumes and water.
j
Qty. (1) Carriage bolt ½-13 x 2.25 GR5
k
Qty. (4) Spacer
l
Qty. (3) Conical washer
1. Remove trunk panel to gain access to end panel. Remove spare tire cover.
2. Remove (2) trunk rubber plugs located in the end panel. Return to owner.
3. Place carriage bolt and spacers (2) onto tow hook. As shown Figure 1.
4. Raise hitch into position behind end panel and fasten to tow hook with conical washer and hex nut. Hand tighten.
5. Install fasteners on drivers side. Place spacer (Item 2) inside trunk add sealant around hole. Install fastener as
shown in Figure 1 or optional Figure 2. Hand tighten to prevent hitch from moving while installing passenger side.
6. Install fastener on passenger side. Once again adding sealant around hole. Install fasteners as shown in Figure 1
or optional Figure 2 .
7. Tighten all fasteners to specification listed below.
8. Apply sealant at bolt attachments inside spare tire well to prevent the intrusion of water and exhaust fumes to
vehicle interior.
9. Reinstall trunk panel. Reinstall spare tire cover
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2008, 2015 Cequent Performance Products – Printed in Mexico
Installation Instructions
Chevrolet Aveo Sedan
Fascia
Drawbar Kit:
3593
(Sold separately)
Drawbar must be used in the
RISE position only.
Remove
rubber
plugs
j
k
k
Tow hook
l
m
l
m
Tighten all ½" Gr5 fasteners with torque wrench to 75 Lb.-Ft. ( 102 N*M)
Do Not Exceed Lower of Towing Vehicle
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (91 Kg) Max Tongue Weight
Wiring Access Location: PC3, 4
End panel
Bar
k
n
Inside
trunk
Figure 1.
m
Qty. (3) Hex nut ½-13
n
Qty. (2) Carriage bolt ½-13 x 2.00 GR5
o
½" Pull wire
Qty. (1)
Sheet 1 of 3 24810N
Part Numbers:
24810
60896
77181
Manufacturer's Rating or
End panel
k
Bar
ml
Inside
trunk
End panel
Bar
lm
Optional trunk
fasteners assembly
Spacers (item 2)
must be inside of
trunk.
Figure 2.
Optional fasteners assembly.
10-09-15 Rev. B
Form F206 Rev A 5605
n