Cequent Towing Products 65029 Instrucciones De Instalación

Receiver Shown In Proper Position
Equipment Required:
Fastener Kit: K65029
Wrenches: 7/8", 15mm, 18mm
Drill Bits: None
Hacksaw
1
Qty. (4) Hex Bolt, M12 x 1.75 x 45
2
Qty. (6) Conical Washer, 1/2"
3
Qty. (2) Carriage Bolt, 1/2"-13 x 2"
4
Qty. (10) Spacer, 1-1/2" x 2" x 1/4"
1. Remove plastic shield and return to vehicle owner.
2. If equipped, lower plastic skid plate and notch in area shown above.
3. Remove existing fasteners from bumper brackets.
4. Raise receiver into position and install either M12 hex bolts into existing weldnuts in bumper brackets or if no weldnuts are present use
optional fasteners shown above.
NOTE: Use 1-1/2" x 2" x 1/4" blocks (provided) as spacers between hitch and frame rail if needed.
5. Feed carriage bolts and blocks through access hole in crossmember using pull wire as shown above.
6. Reinstall skid plate if removed in Step 2.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
Dodge Dakota 4X4
Dodge Durango 4X4
Bumper
Remove
Plastic Shield
Optional
Plastic
Skid
Plate
Tighten all skid plate fasteners with torque wrench to 17 Lb.-Ft (23 N-m).
Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Tighten all 1/2" GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
CARGO CAPACITY – DO NOT EXCEED
Bumper Bracket
Existing Weldnuts
Crossmember
Frame
Access Hole
Notch Skid Plate
In Area Shown
5
Qty. (6)
6
Qty. (4)
7
Qty. (2)
Sheet 1 of 3
300 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL
9000
NOTE: All Fasteners Typical
Both Sides Of Vehicle
Rail
Optional
Recovery Eye
Hex Nut, 1/2"
Carriage Bolt, 1/2"-13 x 1-3/4"
Pull Wire, 1/2"
N65029 11/07/05
Part Numbers:
65029
Optional
Fasteners
Rev. A