Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Receiver Shown In Proper Position
Hitch Requires 5/8" Pin and Clip
Equipment Required:
Fastener Kit: F65024
Wrenches: 8mm, 10mm,
12mm, 7/8"
Drill Bits: 1/2"
Frame
Rail
Enlarge Holes
1
Qty. (6)
Carriage Bolt, 1/2"-13 x 1-3/4"
2
Qty. (6)
Spacer, 1" x 2" x 1/4"
3
Qty. (6)
Conical Washer, 1/2"
1.
If present lower plastic radiator shield or skid plate.
2.
Enlarge six (6) existing holes in frame rails as shown in Figure 1.
3.
Feed blocks and carriage bolts through access hole into position using pull wire.
4.
Raise receiver into position and install conical washers and hex nuts. See Figure 1.
5.
Check clearance of transmission cooler line. Bend or tie back to prevent contact with receiver as shown in Figure 2.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. Do not cut, weld, or
modify hitch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
Ford Ranger
Mazda B-Series Trucks
Frame Rail
Bumper Fascia
FIGURE 1
Tighten all 1/2" GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
9000
Transmission
Cooler Line
4
Qty. (6)
Hex Nut, 1/2"
5
Qty. (2)
Pull Wire, 1/2"
Sheet 1 of 3
N65024
Part Numbers:
65024
LB. MAX. WINCH LINE PULL
Radiator
Check
Clearance
Crosstube
FIGURE 2
11-07-05
Rev. A
Publicidad
Manuales relacionados para Cequent Towing Products 65024
Resumen de contenidos para Cequent Towing Products 65024
- Página 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 N65024 11-07-05 Rev. A 2005 Cequent Towing Products...
- Página 2 Ne pas découper, souder ni modifier l’attelage. Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 2 de 3 N65024 11-07-05 Rev. A 2005 Cequent Towing Products...
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684 Hoja 3 de 3 N65024 11-07-05 Rev. A 2005 Cequent Towing Products...