Cequent Towing Products 65022 Instrucciones De Instalación

Ford F-250 & F-350 Superduty Pickup, Excursion (All Models)
Frame
Rail
Bumper
Bracket
Receiver Shown In Proper Position
Equipment Required:
Fastener Kit: K65022
Wrenches: 3/4", 15mm, 18mm
Drill Bits: 5/8"
CAUTION: HOLD HANDLENUT IN PLACE
TO PREVENT IT FROM ROTATING INTO
AIR CONDITIONING CONDENSER.
Shim Plate, If Present
Remove and
Return To Customer
Both Sides
1
Qty. (4) Handle Nut, 1/2"
2
Qty. (4) Spacer, 1-1/2" x 2" x 1/4"
NOTE: OPTIONAL OEM FOG LIGHTS MUST BE REMOVED FOR RECEIVER INSTALLATION.
1. Remove six (6) bumper bolts, bumper and (2) shim plates if present.
2. Remove OEM tow hooks if present.
3. Place bumper on protected surface to prevent scratching. Place receiver inside bumper. See Figure 2.
4. Loosen six (6) nuts to remove lower front cross member (if equipped).
5. Center receiver hole pattern side to side on bumper hole pattern. Mark location of drilled holes in bumper, in center of receiver slots. See
Figure 3.
6. Remove receiver from bumper and drill marked holes with 5/8" drill.
7. Place receiver on frame.
8. Reinstall lower front cross member (if equipped).
9. Reinstall OEM tow hooks removed in Step 2.
10. Reinstall bumper using four (4) fasteners removed in Step 1. Do not install shim plates.
11. Install remaining fasteners as shown in Figure 1. CAUTION: HOLD DRIVER'S SIDE HANDLE NUTS IN PLACE TO PREVENT
THEM FROM ROTATING INTO AIR CONDITIONG CONDENSER.
12. Return shim plates to customer.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
F-350, F-450, & F-550 Cab & Chassis With 34" Frame
Bumper
Existing
Nut Plate
FIGURE 1
Tighten all fasteners with torque wrench to 50 Lb.-Ft (68 N-m).
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
9000
Drilled
Holes
Existing Bolts
3
Qty. (4) Conical Washer, 1/2"
4
Qty. (4) Hex Bolt, 1/2"-13 x 1-3/4"
Sheet 1 of 3 N65022
Part Numbers:
65022
LB. MAX. WINCH LINE PULL
Back Of Bumper
Drilled Holes
FIGURE 2
Drilled Hole
Existing Hole
Hitch
Drilled Hole
FIGURE 3
11-07-05
Existing
Hole
Rev. B