Cequent Towing Products 65051 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 65051F
Wrenches: 7/8", 17mm, 18mm
Drill Bits: None
Tie down / Tow loop
This 1" diameter tow
loop is an option on
some models
This is a magnified view
of a Bolt Leader
1
Qty. (4) Hex bolt – M12 x 1.25 x 55mm Cl 8.8
2
Qty. (6) Conical washer – 1/2"
3
Qty. (2) Carriage bolt – 1/2"-13 x 2"
NOTE: Vehicles with front skid shield require skid shield removal for access to engine oil filter. It is recommended to
remove skid shield when installing this hitch.
1. Remove existing tie down / tow loop and keep for reinstallation. Two wheel drive may only have a tie down loop pointing down.
2. Raise hitch into position as shown and reinstall tie down / tow loop with fasteners provided. Do not tighten bolts yet.
3. With vertical bolts loose, use bolt leaders provided to install carriage bolt and block into the frame (see figure 2). Part of the plastic
wheel well will cover half the access hole, this can be temporarily pushed out of the way. Keep bolt and block separate until
inside frame. Do not pull bolts through the side mounting hole yet.
4. Route each of the bolt leaders though the mounting brackets. Tighten vertical bolts to raise hitch into final position. Pull bolt leaders
to install the side mounting bolts through mounting brackets. Install Conical washers and nuts as shown.
5. Tighten all fasteners to spec.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z
2007, 2008 Cequent Towing Products
Installation Instructions
TOYOTA TUNDRA
Front bumper fascia
12
Vertical bolts
Figure 1
Tighten all M12 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Tighten all 1/2" fasteners with torque wrench to 75 Lb.-Ft. (102N*M)
CARGO CAPACITY – DO NOT EXCEED
500 LB. (227 Kg) OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
9000 LB
4086 Kg
Frame rail
Access hole
4
Qty. (2) Block – 1/4" x 1" x 3"
5
Qty. (2) Hex nut – 1/2" - 13
6
Qty. (2) Bolt leader
Sheet 1 of 3 65051N
Part Numbers:
65051
MAX. WINCH LINE PULL
MAX. WINCH LINE PULL
Figure 2
Side mounting hole
2
34 5
Side mounting bolts
Mounting bracket
6-18-08 Rev. B
Bolt
leader