USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
WATER TANK FULL ALERT
When the Water Tank is full, the
The compressor will shut off. To switch off the
replacing it ensure the tank is secured properly in place.
IMPORTANT: Do not place the Water Tank on the floor when full. In case of an uneven base which may
cause the tank to spillover.
TIMER CONTROL
The dehumidifier can be set to automatically switch ON or OFF for a selected period of time (between
1-24 hour intervals). The Timer hours selection is displayed on the Temperature Display.
NOTE: Before setting the Timer control, make sure there is power to the unit.
Auto-Off Timer:
While the unit is running, press
will flash, press
to select the number of hours (1-24 hours) you want the unit to run before it
switches off. In 5 seconds without further operation, the Timer starts function. Timer must be set
again after each use.
Auto-On Timer:
When unit is in Standby Mode, press
will flash. Press
to select the number of hours (1-24 hours) you want the unit to turn on. In 5
seconds without further operation, the Timer will start to function. The previous fan speed and
humidity setting will be maintained. The unit will turn on and continue running until the Water Tank
is full or until you switch it off manually. Timer must be set again after each use.
NOTE: To cancel any Timer settings, simply press
disappear.
NOTE: The Power indicator light will illuminated, it indicates the unit is on Standby Mode.
indicator will be illuminated. The unit will beep within 15 seconds.
indicator light, empty the Water Tank and when
, the indicator light will illuminated and the Temperature Display
, the indicator light will illuminated the Temperature Display
again, and the timer
EN
12
indicator light will