Display Explanations - HoMedics THERA-P BPA-300 Manual

BPA-300-A.qxd 10/5/06 4:20 PM

DISPLAY EXPLANATIONS

Date/Time Indicator
Page 9
Systolic
Pressure
Diastolic
Pressure
Pulse Rate
9
Display Symbols:
User 1: Appears when the monitor is operated by User 1.
User 2: Appears when the monitor is operated by User 2.
Weak Battery Symbol: Appears when batteries should be
replaced.
Pulse Symbol: Shows the pulse rate per minute.
Irregular Heartbeat Detector: Indicates an irregular heartbeat
was detected. See page 22 for more information.
Memory Average: Displays average of last 3 readings
Risk Category Indicator: Compares readings against blood
pressure guidelines. See page 21 for more information.
If any of the following letters and numbers appear in the area that
diastolic pressure should be displayed, an error has occurred
with your reading. See Troubleshooting section of this manual for
more information.
Measurement Error: Measure again. Wrap the cuff
correctly and keep arm steady during measurement.
Air Circuit Abnormality: Check cuff connection. Measure again.
Pressure Exceeding 300 mmHg: Turn the unit off to clear,
then measure again.
Data Error: Remove and reload the batteries.
Recalibration Alert: Recalibration recommended. See
page 26 for information.
10