Cequent Performance Products 36594 Instrucciones De Instalación página 4

1. Bumper fascia removal – use panel removal tool to remove (3) plastic rivets from
bottom fascia. Use T15 driver and 7mm socket to remove (5) screws from wheel well liner
each side, see Figure 2. Open the trunk. Using plastic trim tools, gently remove the plastic
fascia starting at the outer edges near the wheel wells. Disconnect the wiring from fascia if
equipped.
2. Bumper beam removal – use 15mm socket to remove
(2) flange nuts and (2) bolts from bumper beam each
side, see Figure 3. Gently remove bumper beam and
exhaust rod hanger. Use a support to keep muffler from
getting damaged.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
3. Hitch installation – raise the hitch and align top 2 holes of the hitch to the studs on
the bumper end panel. Raise the bumper beam and exhaust rod hangers to sandwich
the hitch, see Figure 1. Reuse the flange nuts and bolts to loosely fasten them.
4. Tighten all fasteners with torque wrench to 53 Lb.-Ft. (72 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Sheet 4 of 15 36594NP 09-15-16 Rev. A