Setting Up The Freezer; Electrical Supply; Starting Up; Operating The Freezer - J.P. SELECTA 2000150 Manual Del Usuario

dry clean cloth. Never use any kind of solvent or other chemicals
5. Setting up the freezer
The freezer should not be placed where it might be splashed with water, in extreme high humidity or in
direct sunlight. Any of these factors may lead to a reduction in performance and shorten the life span of the
components. The freezer should be placed on a horizontal level, and should not be placed close to a heating
appliance or heating tubes.
Allow a minimum of 50mm clearance on the side and the back. The side with the ventilation grill should
have a clearance of at least 100 mm in order to allow the heat from the compressor motor to dissipate.
Underneath the appliance, these should be a gap of 15 mm approx. On a soft surface, e.g. carpet, it may be
necessary to ensure the correct distance by means of spacers.
6. Electrical supply
The electrical supply should always be in accordance with the rating plate on the back of the freezer.
The supply must always be in accordance with the law and regulations regarding electrical safety.
If any doubts, contact your supplier.
7. Starting Up
In case the compressor does not start when the freezer has been plugged in, the electrical supply may not
be in order. Check if there is an electricity supply to the plug or if the fuse is blown.
8. Operating the freezer
The empty freezer should be switched on for at least 24 hours prior to loading of the freezer.
The freezer should not be loaded above the inside walls which is also the load line limit.
Please note: After the lid has been opened, there will be a vacuum created inside the freezer due to the low
temperatures. Wait a few minutes before trying to re‐open the lid otherwise the handle could be damaged.
The freeze storage system is based on a PCM material, to ensure the correct response keep it freezed for a
long time (1 week). Take care about your samples before to load in.

9. Defrosting

In order for the freezer to work to its maximum efficiency the cabinet should be defrosted when an approx.
2mm thick ice layer has formed inside the cabinet. Keep the freezer off for a long time with the lid open.
Never use a sharp metal object, which might will cause damage to the inner liner.
The defrosting frequency is determined mainly by two factors the usage pattern (number of lid openings)
and the relative humidity.
Excess water can be drained out by using the drain water outlet on the front of the freezer.

10. Cleaning

Cleaning should be done when needed.
When used in a dirty environment it might be necessary to remove the compressor compartment grill, and
clean the compressor compartment eventually with a vacuum cleaner.
If the cleaning process is neglected, there is a risk that the performance of the freezer will be effected, and
even damage to the compressor could occur due to overheating.